Access control magnetic lock wiring diagram and installation steps

Magnetic lock

The strong suction force tightly sucks the adsorption iron plate to achieve the effect of locking the door. As long as the small current electromagnetic lock will generate a great magnetic force, the access control system that controls the electromagnetic lock power supply will be powered off after the correct identification personnel, and the electromagnetic lock will lose its suction to open the door. Because the electromagnetic lock has no complicated mechanical structure and the structure of the bolt, it is suitable for the passage control of the escape door or the fire door. The inside of the lock body is protected by infusion of epoxy. At present, the suction strength of the electromagnetic lock is expressed in lb (lb), and the test method is static pressurization. The so-called static pressure is that the electromagnetic lock gradually increases the pulling force on the adsorption iron plate after the electromagnetic lock is energized. When the suction force of the electromagnetic lock is exceeded, the adsorption iron plate is pulled open instantaneously, and the data of the tension force is the tensile value of the electromagnetic lock. Moreover, the force of the electromagnetic lock and the absorbing iron plate must be face to face and a collinear load test, so that the holding force of the electromagnetic lock is the largest. The adsorbed iron plate may be temporarily magnetized due to the magnetic induction of the electromagnet for a long time.

Magnetic lock installation method

Surface mounting method for external opening

The first step: first open the cover with a screwdriver, then use a hex wrench to hit the edge board, ready to install

Step 2: Take out the installation board, fold the board along the dotted line, place the board in the position where you want to lock it, and then mark the place where you need to punch the hole and punch it.

third step:

A Following the fixing of the iron plate, insert the hexagon socket screw into the iron plate, place the rubber washer between the two metal washers, and then set it on the hexagon socket screw. Insert the iron plate into the three holes on the door and insert the mushroom head from the other side of the door. Use a hex wrench to lock the iron plate to the door.

B. Fix the side plate and fix the side plate with the two semi-circular head screws on the previously punched door frame (fixed in the long hole of the side plate). Note: Do not lock the side panel so that it can be moved back and forth to facilitate the correction of the position.

C Correct the position of the side plates so that the position of the side plates and the secondary iron plates are appropriate, so that the lock body can be in close contact with the secondary iron plates.

D After fixing the lock body and the semi-circular head screws of the side panel locking side plate, lock all the countersunk screws, then remove the semi-circular head screws and drill holes in the appropriate positions for wiring. Finally, lock the lock body to the side panel with a hex wrench.

Step 4: Wire according to the instructions in the manual.

Step 5: Cover the cover and insert the small aluminum cylinder into the screw hole of the lock body.

Access control magnetic lock wiring diagram