How to install ESD anti-static access control system

How to install the ESD anti-static access control system? The installation determines whether the whole project is qualified or not. How to install the ESD anti-static access control system reasonably is the best? Let Zecheng Intelligent technology company share what should be paid attention to when installing the ESD anti-static access control system several questions:

1. ESD anti-static access control system to determine the plan.
When communicating with customers, determine the plan, the width and length of the site, and determine how many machines can be installed, whether to choose a vertical ESD anti-static access control system, or a bridge ESD anti-static access control system, and the overall dimensions of the vertical ESD anti-static access control system ：420x330x980(mm), Bridge ESD anti-static access control system dimensions: 1200x280x1000(mm), ESD anti-static access control system rod to chassis size 510mm, that is, vertical ESD anti-static access control system area: 420x(330+510) ), the bridge ESD anti-static access control system covers an area of 1200x (280+510), and the gap between the gate and the gate rod is fully considered when determining the type. The area and placement of each ESD anti-static access control system , How to wire (whether to use the open wire or the dark wire), the plan is set, the goal is set, and the ESD anti-static access control system is waiting for the scene.

2. Fixed location wiring.
According to the previously determined plan, clarify the specific installation dimensions of the ESD anti-static access control system, make a pre-embedded pipe, leave a 50-100mm gap between the gate and the gate, and open the upper cover to prevent machine adjustment, maintenance, etc. Never leave a gap. Two plastic pipes of 6-8 minutes are embedded between the turnstile and the turnstile. One hose is used for the power line (strong current), and the other is used for the signal line (weak current). The power line and the signal line run a rubber tube at the same time, which will affect the effect of communication. The embedded tube should be exposed to the ground 30-40mm high, and the vertical ESD anti-static access control system should be at the bottom of the machine. Bridge-type ESD prevention The electrostatic access control system should be on both sides (because the bridge-type ESD anti-static access control system has a closed bottom in the middle).

3. Fixed adjustment.
The bottom of the fixing is fixed with 4-M10x100 expansion screws. It cannot swing. The whole machine is level and the appearance is consistent. (Before fixing, draw a straight line with a thin line, the vertical and horizontal directions are the same). The ESD anti-static access control system and the ESD anti-static access control system are used between the ESD anti-static access control system and the ESD anti-static access control system. The series connection mode can be adjusted one by one, and the straight line can be used normally.